Swaps

Guide - How to start swapping on ProxySwap

Degen Layer 3 uses $DEGEN as it's fee token.

Did you already bridge $DEGEN to Degen Layer 3? Jump to Step 6 - Swapping on ProxySwap

Step 1 - Bridging funds to Degen Layer 3.

Go to bridge.degen.tips. Connect your wallet of choice.

Step 2

Select network to bridge From and corresponding token of choice to bridge. If it's your first time bridging, choose $DEGEN.

Step 3

Select Degen L3 icon on the network To section and chose which token to bridge. If it's your first time bridging, select Degen

Step 4

Click on Approve Token and clickSwap next to finish the bridging process.

Approve Token transaction might not be necessary if you've already approved previously, in that case you only need to click Swap.

Step 5

Wait a few seconds and confirm that the transactions is successful. Your token has been bridged to the Degen Layer 3.

Depending on network congestion transaction can take up to a few minutes to be processed by the network.

Step 6

Go to proxyswap.tips and connect the same wallet. Make sure to change the network on your wallet to Degen Layer 3.

Step 7

Select the token pairs to swap from & to and click swap

To buy PROXY, select it or paste it's contract address on the You receive selector.

PROXY Contract Address: 0xA051A2Cb19C00eCDffaE94D0Ff98c17758041D16

Step 8

Your swap is successful. Tokens can be found in your wallet.

Depending on which wallet you use, you might need to add the token with a 'import token' option, refer to your wallet's docs if needed.